Start at the door that will not close
People call about a door before they call about a house. In July and August an exterior door in Houston swells. The slab of the door takes on moisture, the strike no longer meets the latch, and someone sands the top until it closes, then lives with a gap in January when the air conditioner has dried the house back down. Planing is sometimes the right small repair. It is the wrong repair when the frame has racked, the hinge screws are spinning in soft wood, or the threshold is rotting because the stoop holds water.
Interior doors tell a different story. Clay soil under a Houston slab moves between a tropical rain and a dry stretch. A door that suddenly rubs the head or the latch side may be reporting that movement, not a bad paint job. We look at the gap all the way around, at the hinges, and at whether the floor in that room is still the floor the jamb was built on. A new floor that is thicker than the old one will make every door drag. That is a carpentry problem created by a flooring choice, and it should be said before the doors are cut short.
Trim that belongs to the house
Montrose, Garden Oaks, and Oak Forest still have casing and base profiles worth keeping. A new piece from a big-box bin next to a 1940s shape looks like a patch even when the paint matches. We look at the existing profile before we recommend new. If that shape can still be milled or found, we use it. If it cannot, we show you the closest one in the room, in the daylight, before it runs around the whole wall.
Newer houses in Cypress, Spring, and Kingwood often have the opposite problem. The trim is thin, the corners are coped poorly, and a built-in or a thicker base is what the room is missing. That work is measured to the wall that is there, including walls that are not plumb. Wood that arrives on a humid afternoon needs to sit in the house before it is cut to a tight length. Fastening it straight off the truck is how a joint opens in a week.
- Look at the bottom of window stools and the first inch of door casing. Soft wood is usually a leak or condensation, not old age alone.
- Check the outside sill and the caulk before you blame the interior paint.
- If the wall behind the trim was wet, the wall has to dry before new wood closes it.
- Photograph a profile you want matched, including the corner, before anyone pulls it off.
Rot is not a paint problem
Window stools in Houston go soft when a seal fails, when the air conditioner drips inside the wall, or when a bath on the other side of the wall was never waterproofed. The paint can look fine while a screwdriver sinks in. We open enough to see the end of the softness. Replacing only the face of the stool, and leaving wet wood in the wall, buys the same repair again. If the leak is still active, the carpentry waits. New casing on a damp wall will stain and swell.
A supply-line leak under a window or behind a pantry does the same thing lower down. Swollen baseboard, a soft stud, and a stain that keeps returning are one problem. If insurance is involved, Elite works with your insurance company as your contractor and negotiates the claim scope with the adjuster. We are not public adjusters. Your insurer decides coverage. We separate the dried repair from any new built-in you want in that same wall, so the photos match what failed.
Built-ins, stairs, and what the job costs
Shelves in an alcove, a closet that was never finished, and a stair skirt that has been painted ten times are ordinary Houston carpentry. The wood is scribed to the wall. An alcove in an older house is rarely square, and a shelf cut from a drawing of a square alcove will show a wedge of daylight. Stairs need the same honesty: the skirt, the tread that rocks, and the rail that is loose are looked at before anyone talks about stain.
Cost follows how much wood is soft, whether the profile can be matched, how many doors are involved, and whether the wall has to open. A single stool is not a run of new base through a house. Paint is usually the last step, once the joints are set, and it is a different trade from the carpentry even when we do both. Interior trim rarely interests an HOA. Those reviews, in Kingwood, Cypress, and Fulshear, are about fences, roofs, and the color of the front. A permit is a city or county question, and it shows up when the work is structure.
Before you sand the door yourself
Sanding the top of a swollen door can be fine for one humid week. It is a poor habit if the hinge side has dropped or the threshold is soft. You will shorten a door that then whistles in the air conditioning. Call (713) 909-0034 to schedule an estimate and say which door, and whether the wood is soft or only tight. We have been family-owned, serving Houston since 1993. The visit is at the house, with the door in the weather it is actually failing in.
Questions
Good to know.
Why do doors stick in the summer and not in January?
Exterior doors take on moisture when the air is heavy, and they swell. Interior doors more often stick because the slab or the frame has moved, which Houston clay does between a wet week and a dry one. We look at which door, and at the hinge side, before we plane anything.
Can new trim match an old Montrose or Garden Oaks house?
When that profile can still be found, yes. When it cannot, we show you the closest shape before it goes on the whole room. Covering a soft stool with a new piece of trim only hides the rot.
Does interior carpentry need a permit?
Baseboard, doors, and shelves usually do not. Opening a wall, changing a header, or repairing structure can. We do not pull a permit for casing. We name it when the carpentry is really a structural repair.
Should rotten wood be painted or replaced?
Replaced, once you can see how far the softness goes. Paint on punky wood fails, and it traps the moisture that caused it. If a leak started the rot, the leak has to be finished before the new wood goes on.
